Easiest Way To Pull Up Carpet Tack Strips

Begin at the top of the stairs.

Easiest way to pull up carpet tack strips.

If you can t do this by hand use a carpet claw or a pair of pliers to grip and pull the carpet. If you re removing your old carpet and planning to install new carpet in its place you don t have to remove. Pull it up with 10 tools needed to remove carpet. In most cases the carpet padding will also need to be replaced or removed.

The strips of metal nails under your carpet and carpet padding are called tack strips. It should be replaced if it is old or stained or has gotten wet. Then grab the carpet by hand and continue to pull it up along an entire wall. Remove the carpet padding underneath.

Step 5 remove the carpet tack strips. To detach the carpet from the tack strip that holds the carpet in place along walls start in a corner. Fold back about 3 ft. You may also need to remove your carpet if you have hardwood floors underneath that you would like to refinish.

Pick somewhere to start either a corner or a break between two tack strips. Once you ve lifted the strip closest to the wall enough to get underneath it have a helper cut through the adhesive with a floor scraper while you continue pulling using either the carpet claw or a carpet peeler. Carpet padding is usually just stapled down. Roll or fold the strip secure with duct tape and remove it from the room.

If you are pulling up carpet from stairs. Carpet tack strips can usually remain in place but look for rust rot or other damage. My husband and i have gotten pretty good at removing carpet 3 different homes and at least 3600 sq ft of it. Some people have a hard time with this step but i ll show you how to remove carpet tack strips the easy way with three simple tools.

Removing old carpeting may be necessary to save labor costs if you are having your carpet replaced. Use the 6 in 1 painter s tool and a hammer to lift one end of one of the strips. Carpet removal is a beginner friendly diy project and an easy way to. Continue pulling up carpet a few feet at a time and cutting it into easy to handle strips.

After pulling up your carpet you will most likely have tack strips left around the perimeter of the room. A very easy way to remove carpet tack strip from the basement concrete floor. Pull one corner of the carpet off the floor. Its not that hard with these tips from clay king from aaa flood drying with 28.

Of carpet and cut it into easy to handle strips photo 1.