Electrolux Washer No Water Error Message

Tap closed or water pressure too low.

Electrolux washer no water error message.

If they are clogged flush them out. Water fill solenoid valve is faulty. Turn the water off and remove the hoses from the back of the washer. Turn the water on to make sure you have good water pressure from both hot and cold water lines.

Disconnect the fill hoses from the back of the washer and put them in a 5 gallon bucket. You ll need to pull the washer forward and turn the water off to the washer. Drain tube improperly dositioned. Washer dryer displays error message e30 c3 or emits 3 beeps.

Water fill solenoid valve is faulty. Tap closed or water pressure too low. If the hoses are good and you haven t found anything slowing down the flow of the water your electronic inlet water valve is just faulty on the back of your washer and will need to be replaced because it s just not allowing water flow into the washer correctly. Leaks from water circuit on pressure switch.

The error is caused by water at the bottom or inside the machine. Check the little filter screens where the fill hoses connect to the back of the washer.